Omni Group Superplus - Page 2

EC- DECLARATION OF CONFORMITY
under Annex II.A of the 2006/42/EC Directive on Machines
DECLARES
Under his sole responsibility that the machine TURNTABLE MACHINE WITH AUTOMATIC
WORKING CYCLE designed for winding pallet loads with extensible film
Model: Omni SUPERPLUS
IS IN CONFORMITY with the following provisions:
- European Community Directive 2006/42/EC – on the safety of machines;
NOTE: the Directive 2006/42/EC replaced the Directive 98/37/EC and its amendments
- European Community Directive 2014/30/EU and amendments – on Electromagnetic Compatibility;
NOTE: the Directive 2014/30/EU replaced the Directive 2004/108/CE and its amendments
- National decrees that implement the Community Directives mentioned above.
List of the Harmonized Technical Rules applied:
EN 12100-1
Safety of machinery -- Basic concepts, general principles for design -- Part 1: Basic
terminology, methodology
EN 12100-2
Safety of machinery -- Basic concepts, general principles for design -- Part 2: Technical
principles
EN 60204-1
Electrical equipment of the machines Part 1: General requirements
EN 61000-6-2
Electromagnetic compatibility (EMC) – Part 6-2: Generic standards – Immunity for
industrial environments
EN 61000-6-4
Electromagnetic compatibility (EMC). Generic standards. Emission standard for industrial
environments
With
a view to continuous improvement of this machine’s functions, some of its components and/or
characteristics could be modified without notice and without prejudice to the validity of this
document. If differences are found between the contents of this manual and the actual machine
operation, please communicate them to the Builder.
Omni SUPERPLUS EN IGM_REV6 3