OMNI 4000/7000 Installation Guide – Rev H
You are now connected to the flow
computer (online), but you are not yet
receiving data.
Click the Receive button in the Home
ribbon to open the Receive Data from
OMNI Unit window and receive the
default configuration from the
flow computer.
The Receive Data from OMNI Unit window will present a message that contains
firmware license information, which lists the features that are licensed in the firmware
of the OMNI flow computer and the features that are not licensed.
Click Start to receive the data from the
unit and continue initial configuration.
If you are trying to connect to a unit
through an Ethernet site and an error
message pops up, click OK on the
message and click Cancel on the
Connect to OMNI window.
Continue to Step 7.
An error message may mean that
your OMNICONNECT Site file
settings do not match the
configured port settings on the
Omni 4000/7000.
To Next Page
Loading...