Omni 4000 Series - Port Security

OMNI 4000/7000 Installation Guide – Rev H
4-47
Configuration
Some items within OMNICONNECT cannot be viewed when the user does not have permission.
These items include:
• General Access
− Receive Configuration from OMNI, which is disabled on the ribbon bar and when the
user expands the Configuration Tree or the Report Editor Tree
− Transmit Configuration to OMNI, which is disabled on the ribbon bar and when the user
expands the Configuration Tree or Report Editor Tree
• Customize
− Edit Custom Reports, which is disabled on the ribbon bar. When the user expands the
Report Template Editor Tree, the Work Online with Templates option is disabled.
4.8.4 Port Security
Similar to configuring user security, the default setting on the flow computer for port security by
the firmware is disabled. The Administrator must manually enable security for ports, and only the
Administrator may configure port security.
Port security is automatically bypassed for gas chromatographs, peer to peer master
and slave serial ports.
To edit port security while logged in as the Administrator, follow these instructions:
1.
Click the Security button in the Home
ribbon to open the Security tree in the
left panel.
2.
In the left panel, expand the tree under
Administrator and under Ports to see
the list of all the ports reflected by the
modules installed on the flow computer.