Omni 4000 Series - Page 35

OMNI 4000/7000 Operations and Maintenance Guide – Rev F
3-12
OMNICONNECT® Operations
7.
In the left column of the Setup screen,
enter the override values and select the
preferred calculations for this product.
8.
Depending on which Density Method you
chose, the available applications in the
right-hand column may change.
a. Click on any of the HV, SG, N2 or
CO2 buttons to open their
configuration windows, and assign
source inputs, alarms and overrides,
as needed.
b. Click OK to save the changes and
close the window.
Viscosity and Isentropic
Exponent information are required
only for differential pressure
devices.
Configuration of these selections is
optional and is not necessary if
these values are being provided by
a Gas Chromatograph (GC).