Omni Base User Manual

The machine should be connected to the power
supply by means of an industrial plug. Electric
supply must be provided in conformity with the
relevant legislation in the country of use. Supply
tension should be the same as specified in the
nameplate specifications.
Electrical connection cables must be
protected and so located as not to hamper
operators.
After all preliminary controls have been carried out and the electrical connection has been correctly
performed, the machine can be connected to the power supply. Then, check that all machine parts
and devices work correctly.
CEC BASE IGM REV13 38

Omni Base Specifications

General

Wrap Height Max	80"
Film Width	20"
Load Weight Max	4000 lbs
Load Capacity	4000 lb
Turntable Speed	12 RPM
Wrapping Speed	12 RPM