The machine identification plate, listing the technical data, the serial number and the marking, is
visibly located on the column, as shown in the picture below.
THE IDENTIF
ICATION PLATE MUST NEVER BE REMOVED.
1.10 GENERAL SAFETY INFORMATION
During project and manufacturing phases, the Builder paid careful attention to all those situations
that might cause risks to the safety and the health of people. The relevant laws were fully
respected and all the “rules of good building technique” were applied. The aim of this type of
information is to raise the awareness of users on the importance of preventing any risk, always
using caution.
Carefully read the i
nformation reported in the manual and placed directly on the machine,
especially safety information.
Please read this
manual carefully before using or servicing the machine.
CEC BASE IGM REV13 10
sales@omnigroup.com.au
www.omnigroup.com.au
Ph : 1300 764 963
To Next Page
Loading...