Omnia-6ex Use and Operation Manual – V: 1.20
109
Failed to initialize RTC
Description: The operating system could not initialize the Real Time Clock on the motherboard.
Cause: The Real Time Clock chip on the motherboard may have failed.
Resolution: Contact Telos / Omnia Customer Support for assistance.
Dead battery, data lost.
Description: The Lithium battery used for system configuration backup is being reported as dead or
battery voltage is too low for reliable operation.
Resolution: Contact Telos / Omnia Customer Support for assistance.
Timed out loading DSP.
Failed DSP #x Bootstrap, contact CE.
Description: The operating system was not able to initialize one of the Omnia’s DSP cards or one of the
two DSP IC's on the card.
Cause: One of the DSP cards or DSP chips may have failed.
Resolution: Contact Telos / Omnia Customer Support for assistance.
Host command bit not clear
ERROR: read failed write address, DSP #x
Description: The operating system was unable to communicate with the DSP's host port.
Cause: Possible failure of DSP or motherboard DSP controller / router chain components.
Resolution: Contact Telos / Omnia Customer Support for assistance.
Failed Routing, contact CE.
Description: The operating system was unable to establish the correct signal path routing through the
DSP chain.
Cause: Possible failure of motherboard DSP controller / router chain components.
Resolution: Contact Telos / Omnia Customer Support for assistance.
To Next Page
Loading...
Need help?
General
