CHAPTER 8
| 66
TECHNICAL SPECIFICATIONS
Analog: Left and Right Stereo on EMI-suppressed XLR-3, balanced with “pin 2 hot”.
Input: Electronic balanced, impedance 10kΩ, nominal +4 dBu, max +22 dBu.
Output: impedance 20Ω for >600Ω load, +4 dBu nominal, +22 dBu peak.
Converters: 24 bit, 128x oversampled with linear-phase anti-aliasing filter.
Digital: Stereo per AES/EBU standard, 24 bit resolution. Input locks to any rate 32 kHz – 108
kHz. Output locks to input, internal 48 kHz, or separate external AES/EBU “digital black”
reference 32 kHz – 96 kHz.
Livewire: Audio over IP and control per Livewire standard, on same RJ-45 used for Ethernet
control.
Remote Control
GPI: EMI suppressed DB-9 at logic levels, +5 V and ground supplied.
Ethernet: 10/100BaseTX Ethernet on EMI-suppressed RJ-45. TCP/IP control via HTML-
5 internal web server, password protected. Manual addressing and port selection.
Electrical/Physical
Power: 100 - 250 VAC, 47-63 Hz. < 40 VA. Typical draw 12W RMS, maximum 15W RMS.
Internal supply with overvoltage and short circuit protection. Meets EN55022, EN55011 Level
B Conducted Emissions. EN61000-4-2, -3, -4, -5, -6 level 3 immunity compliant. Full interna-
tional safety approval. CE marked.
EMI suppressed IEC male connector. Detachable 3-wire power cords supplied for US and Euro-
pean use.
Temperature: 32° to 122° F / 0° to 50° C for all operating voltage ranges.
Humidity: 0-95% RH, non-condensing.
Dimensions: 19” wide x 1.75” high x 16” deep (48.26cm x 13.335 cm x 40.64 cm) including
connectors. Unit requires one EIA rack space for mounting.
Shipping Weight: 12 lbs. / 5.5 kg
To Next Page
Loading...