OmniBreeze DC2018 - Remote Control Operation; Remote Control Battery Replacement

OPERATION
REMOTE CONTROL OPERATION
ae zN POWER Turns Fan On/Off.
DURACELIO SPEED SELECTION
VOENNG Canal banda. Keep Allows for 4 different speeds.
oteres any kor he cite See nar
| AERTSSEVENT: Rae bu ch,
Ik C&G
Gort ples eat es OSCILLATION
[eens Switches oscillation On/Off. See page 5 for more details.
|ADVERTENCIA Pegs de quemaduras quinicas |
Marten tes pas jos dl alcance de os
ric Cada WIND SELECTION
MODELMODELEMODELO: SFY22
Allows for three different wind modes.
See page 5 for more details.
OmniBreeze
TIMER
Allows for automatic shut off after preset
time selections. See page 5 for more details.
©
Prior to first-time operation, please remove the clear plastic tab at the base of the remote and remove the
plastic covering from the front of the face (Fig.1). Please make sure the battery is in the remote control.
REMOTE CONTROL BATTERY REPLACEMENT
© On the back of the remote, press the release button on ara
the bottom with a pin or a pencil. This will allow the tray ed
containing the battery to be released. (Fig. 2) psoralen ean
© Replace the battery with 1 “DL2032” button cell battery Geena tei
and dispose of properly and in accordance with local law [seer
and ordinances. Pesa aia
@ Slide the tab back into position until the tray locks into ecearewne eva
the remote.
® DO NOT DISPOSE OF BATTERY IN FIRE,
BATTERY MAY EXPLODE OR LEAK
@ This product contains a button cell battery. If swallowed, it
could cause severe injury or death in just 2 hours.
Seek medical attention immediately.
@ For best performance, we recommend using a
(Fig.1) Duracell DL2032 battery.
(Fig.2)
FCC STATEMENT OF COMPLIANCE
This device complies with part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Note: This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more
of the following measure:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation. CAN ICES-3 (B)/NMB-3(B). This Class B digital apparatus complies with Canadian ICES-003.
-6-