© 2010 Omnicell, Inc. OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D
Drawers 3-5
Installation Procedure
4. Connect the drawer cable to the drawer connect board.
Figure 3-4. Connect the drawer cable to the drawer connect board
5. Place the rail into the support slot in the back of the frame.
6. Line up the rail with the screw holes on the front of the frame and replace the screws.
7. Connect the drawer controller cable to the drawer controller board at the rear end of the
drawer.
8. Secure the drawer controller cable cover with two screws using a T-10 Torx screwdriver.
Figure 3-5. Connect the drawer controller cable to the controller board
9. Attach the slide to the slide support bracket with three screws and washers using a Torx T15
screwdriver.
10. Install the slide support bracket.
To Next Page
Loading...