24
6.6 Synchronisation of the playback-speed
You can synchronise the CD player and another signal-source while cueing with the headphones via the
mixer.
Possibility 1:
Put the CD-player into playback-mode and cue with the headphones. Synchronise the playback-speed via
the Pitchfader ot the CD-player (Pitch-button has to be pressed).
Possibility 2:
If the two signal-sources only differ in the bass-beat, you can synchronise via the Pitch Bend-buttons.
Put the CD-player into playback-mode and cue with the headphones. Synchronise the bass-beat via the left
or right Pitch Bend-button.
6.7 Programming
Create a program:
Press the Program-button and the Program-LED shines. The display shows "- -" for indicating the track-
number, "00:00" for indicating the track-length and "01" for indicating the program-number.
Press one of the Track-buttons until the display will show the desired track number for the program-number
1. Press the Program-button in order to save the track.
Press one of the Track-buttons again in order to choose a track for the next program-number.
Continue programming like this until you have no more tracks to program or the maximum of programmable
tracks (20) is reached.
Check the program:
You can interrupt the programming procedure in order to check the program by pressing the Program-button
once more after you entered a track. Press the Program-button repeatedly and the display will show the
order of programmed tracks. You can edit every program-number and choose a different track.
Read a program:
After entering your last track, press the Program-button and the last track will be memorized. Press the
Play/Pause-button and the program will be played back. During the program-playback, the Program-LED is
shining. You can enter the Program-mode at any time in order to add more tracks by pressing the Program-
button.
Delete a program:
In order to leave the program mode press the Program-button and hold it for approx. 3 seconds or open the
CD tray or switch the device off. As soon as you deleted the program, the Program-LED is off.
6.8. Cueing
The player is in Playback-mode.
Press the Loop In/Fly Cue-button and the Cue-point is memorized. The red Cue-LED shortly flashes twice.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.
6.9 Memorizing a sequence (Loop-function)
With the Loop-function, you can repeat a programmable sequence. Activate the Loop-function by pressing
the Loop On-button.
Memorizing the Loop-points:
Possibility 1:
The player is in Playback-mode.
If the In/Fly Cue-button is pressed in the playback-mode, the CD keeps running and the A-point (starting-
point) is marked. By pressing the Out/Exit-button, the B-point (end-point) of the sequence is marked.
The player repeats the sequence between A-point and B-point until you press the Out/Exit-button once
more.
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
To Next Page
Loading...
