00008423.DOC VERSION 3.3
32/49
TECHNICAL SPECIFICATIONS P-1000, P-1500 & P-2000
P-1000 P-1500 P-2000
Power supply: 115/230 V AC, 50/60 Hz ~ 115/230 V AC, 50/60 Hz ~ 115/230 V AC, 50/60 Hz ~
Power-range: 230 V ± 10 % (206 V -
253 V)
230 V ± 10 % (206 V -
253 V)
230 V ± 10 % (206 V -
253 V)
Power consumption
(max.):
1300 W 2120 W 3500 W
Momentary music peak
power at 1 KHz:
1270 W / 4 Ohms 1950 W / 4 Ohms
Maximum power output: 2 x 582 W / 4 Ohms 2 x 840 W / 4 Ohms
Nominal power output: 2 x 500 W / 4 Ohms 2 x 750 W / 4 Ohms
Power output sine:
Stereo 4 Ohm 2 x 500 W 2 x 750 W 2 x 1000 W
Stereo 8 Ohm 2 x 245 W 2 x 390 W 2 x 625 W
8 Ohms bridged 1 x 850 W 1 x 1250 W 1 x 1875 W
Frequency range: 22 - 31 000 Hz 22 - 31 000 Hz 40 - 40 000 Hz, ± 3 dB
Damping-factor: > 200 > 200 > 400
Distortion factor: 0,01 % 0,01 % 0.01 %
Signal to Noise Ratio: 108 dB 108 dB 90 dB
Channel seperation (at 1
KHz):
89 dB 89 dB 70 dB
Min. input sensitivity: 0,77 V/26 dB/1,44 V 0,77 V/26 dB/1,44 V 0.77 V/26 dB/1.4 V
Input impedance: 12 kOhms (unbalanced),
22 kOhms (balanced)
12 kOhms (unbalanced),
22 kOhms (balanced)
20 kOhms (balanced)
Output impedance: > 0,02 Ohms > 0,02 Ohms
Slew-rate: > 35 V/µsec > 40 V/µsec 60 V/µsec
Input-connectors: 2 x XLR-female-plug, 2 x
1/4"-jack-plug
2 x XLR-female-plug, 2 x
1/4"-jack-plug
2 x XLR-female-plug, 2 x
1/4"-jack-plug
Output-connectors: 2 x Speaker (stereo), 1 x
Speaker (bridge), 2 x
Banana/screw
combination
2 x Speaker (stereo), 1 x
Speaker (bridge), 2 x
Banana/screw
combination
2 x Speaker (stereo), 1 x
Speaker (bridge), 2 x
Banana/screw
combination
Control elements: Power switch, input
attenuators (one per
channel), Mode switch -
Stereo/Parallel/Bridged,
Ground Lift, Input-Level-
Select (0.77 V/26 dB/1.44
V), limiter
Power switch, input
attenuators (one per
channel), Mode switch -
Stereo/Parallel/Bridged,
Ground Lift, Input-Level-
Select (0.77 V/26 dB/1.44
V), limiter
Power switch, input
attenuators (one per
channel), Mode switch -
Stereo/Parallel/Bridged,
Ground Lift, Input-Level-
Select (0.77 V/26 dB/1.44
V), limiter
LED indicators (per
channel):
Power, Protect, Signal,
Mode
Power, Protect, Signal,
Mode
Power, Protect, Signal,
Mode
Protection circuits: Short-circuit, DC-
protection-circuit, Thermal
protection-circuit, Softstart
Short-circuit, DC-
protection-circuit, Thermal
protection-circuit, Softstart
Short-circuit, DC-
protection-circuit, Thermal
protection-circuit, Softstart
Construction: Steel chassis, aluminium
frontpanel
Steel chassis, aluminium
frontpanel
Steel chassis, aluminium
frontpanel
Dimensions: 445 x 482 x 100 mm 445 x 482 x 100 mm 490 x 482 x 100 mm
Minimum mounting depth: 450 mm 450 mm 480 mm
Weight: 12.2 kg 14.5 kg 17 kg
To Next Page
Loading...
Need help?
General
