Omron Ateg H3DT Series - H3 DT-N;H3 DT-L Timing Charts (Part 4); One-shot Output Modes

ATEG Automation GmbH
|
Intzestraße 50
|
42859 Remscheid
|
Germany
|
Tel.: +49 (0)2191 / 591457-0
|
info@ateg.de
|
www.ateg.de
Datenblatt
Zeitrelais H3DT
H3DT
H3DT-N/H3DT-L
11
Note: 1. The reset time is 0.1 s min. Make sure the signal input time is 0.05 s or longer.
2. “t” is the set time. “ta” is a time that is less that the set time.
E: Interval (Signal Start)
G: Signal ON/OFF Delay
J: One-shot Output (Signal Start)
J2: One-shot Output (Power ON Start)
tt tt−at−at−a
Power (A1 and A2)
Time-limit contacts: NC
15 and 16 (25 and 26)
Time-limit contacts: NO
(output indicator)
15 and 18 (25 and 28)
Instantaneous contacts: NC
(21 and 22)
Instantaneous contacts: NO
(21 and 24)
Operation / Power indicator
Start input (B1 and A1)
Timing
* The start input is valid while the Timer is in operation.
Power
Start input
Output
Basic Operation
tt t t − att − a
Power (A1 and A2)
Time-limit contacts: NC
15 and 16 (25 and 26)
Time-limit contacts: NO
(output indicator)
15 and 18 (25 and 28)
Instantaneous contacts: NC
(21 and 22)
Instantaneous contacts: NO
(21 and 24)
Operation / Power indicator
Start input (B1 and A1)
Timing Timing Timing
Timing
* The start input is valid while the Timer is in operation.
Power
Start input
Output
Basic Operation
tt
1 s±0.6 s (fixed)
1 s±0.6 s (fixed) 1 s±0.6 s (fixed)
tt − at − at − a
Power (A1 and A2)
Time-limit contacts: NC
15 and 16 (25 and 26)
Time-limit contacts: NO
(output indicator)
15 and 18 (25 and 28)
Instantaneous contacts: NC
(21 and 22)
Instantaneous contacts: NO
(21 and 24)
Operation / Power indicator
Start input (B1 and A1)
Power
Start input
Output
1 s±0.6 s
(fixed)
* The start input is valid while the Timer is in operation.
Timing
Basic Operation
t t
t − a
1 s±0.6 s (fixed) 1 s±0.6 s (fixed)
Power (A1 and A2)
Time-limit contacts: NC
15 and 16 (25 and 26)
Time-limit contacts: NO
(output indicator)
15 and 18 (25 and 28)
Instantaneous contacts: NC
(21 and 22)
Instantaneous contacts: NO
(21 and 24)
Operation / Power indicator
Power
Output
Timing
1 s±0.6 s
(fixed)
Basic Operation
Erstellt am 09.10.2020 um 23:38 Uhr | Alle Angaben ohne Gewähr, Irrtümer und Änderungen vorbehalten! Seite 12 von 37