ATEG Automation GmbH
|
Intzestraße 50
|
42859 Remscheid
|
Germany
|
Tel.: +49 (0)2191 / 591457-0
|
info@ateg.de
|
www.ateg.de
Datenblatt
Zeitrelais H3DT
H3DT
H3DT-N/H3DT-L
10
Note: 1. The reset time is 0.1 s min. Make sure the signal input time is 0.05 s or longer.
2. “t” is the set time. “ta” is a time that is less that the set time.
A: ON Delay (Signal ON Delay)
B: Flicker OFF Start (Signal Start)
B2: Flicker ON Start (Signal Start)
C: Signal ON/OFF Delay
ttt
−
a
Power (A1 and A2)
Time-limit contacts: NC
15 and 16 (25 and 26)
Time-limit contacts: NO
(output indicator)
15 and 18 (25 and 28)
Instantaneous contacts: NC
(21 and 22)
Instantaneous contacts: NO
(21 and 24)
Operation / Power indicator
Start input (B1 and A1)
Timing
* The start input is ignored while the Timer is in operation
Power
Start input
Output
tt t ttt−at−a
Power (A1 and A2)
Time-limit contacts: NC
15 and 16 (25 and 26)
Time-limit contacts: NO
(output indicator)
15 and 18 (25 and 28)
Instantaneous contacts: NC
(21 and 22)
Instantaneous contacts: NO
(21 and 24)
Operation / Power indicator
Start input (B1 and A1)
Timing Timing Timing Timing
* The start input is ignored while the Timer is in operation
Power
Start input
Output
tt t ttt
−
at
−
a
Power (A1 and A2)
Time-limit contacts: NC
15 and 16 (25 and 26)
Time-limit contacts: NO
(output indicator)
15 and 18 (25 and 28)
Instantaneous contacts: NC
(21 and 22)
Instantaneous contacts: NO
(21 and 24)
Operation / Power indicator
Start input (B1 and A1)
Power
Start input
Output
Timing Timing Timing Timing
* The start input is ignored while the Timer is in operation
ttttt
−at−at−a
Power (A1 and A2)
Time-limit contacts: NC
15 and 16 (25 and 26)
Time-limit contacts: NO
(output indicator)
15 and 18 (25 and 28)
Instantaneous contacts: NC
(21 and 22)
Instantaneous contacts: NO
(21 and 24)
Operation / Power indicator
Start input (B1 and A1)
Power
Start input
Output
Timing
Timing
Timing
Timing
* The start input is valid while the Timer is in operation.
Erstellt am 09.10.2020 um 23:38 Uhr | Alle Angaben ohne Gewähr, Irrtümer und Änderungen vorbehalten! Seite 11 von 37