8
•Remove tight-fitting or thick clothing from your arm while taking a
measurement.
•Remain still and DO NOT talk while taking a measurement.
•ONLY use the arm cuff on persons whose arm circumference is
within the specified range of the cuff.
•Ensure that this monitor has acclimated to room temperature
before taking a measurement. Taking a measurement after an
extreme temperature change could lead to an inaccurate reading.
OMRON recommends waiting for approximately 2 hours for the
monitor to warm up or cool down when the monitor is used in an
environment within the temperature specified as operating
conditions after it is stored either at the maximum or at the
minimum storage temperature. For additional information on
operating and storage/transport temperature, refer to section 10.
•DO NOT use this monitor after the durable period has ended. Refer
to section 10.
•DO NOT crease the arm cuff or the air tube excessively.
•DO NOT fold or kink the air tube while taking a measurement. This
may cause an injury by interrupting blood flow.
•To unplug the air plug, pull on the plastic air plug at the base of the
tube, not the tube itself.
•ONLY use the AC adapter, arm cuff, batteries and accessories
specified for this monitor. Use of unsupported AC adapters, arm
cuffs and batteries may damage and/or may be hazardous to this
monitor.
•ONLY use the approved arm cuff for this monitor. Use of other arm
cuffs may result in incorrect readings.
•Inflating to a higher pressure than necessary may result in bruising
of the arm where the cuff is applied. NOTE: refer to “If your
systolic pressure is more than 210 mmHg” in section 3 of this
instruction manual for additional information.
To Next Page
Loading...
