28
3. Using Your Monitor without a Smart Device
Using the Guest Mode
Your monitor stores readings for 2 users in the memory. The guest
mode can be used to take a single measurement for another user.
•No readings are stored in the memory, and the TruRead mode is not
available when the guest mode is selected.
1. Press and hold the
[START/STOP] button
for more than
3 seconds.
The user ID symbol and the date/time display will disappear.
2. Release the [START/STOP] button when the
user ID and date/time display turn off.
The arm cuff automatically starts to inflate.
If your systolic pressure is more than 210 mmHg
If your systolic pressure is more than 210 mmHg, take a
measurement manually.
After the arm cuff starts to inflate, press and hold the [START/STOP]
button until the monitor inflates 30 to 40 mmHg higher than your
expected systolic pressure.
•Do not inflate above 299 mmHg.
• Inflating to a higher pressure than necessary may result in bruising of the arm
where the cuff is applied.
To Next Page
Loading...
Need help?
General
