Using the Guest Mode
Your monitor stores readings for 2 users in the memory. The guest mode can be
used to take a single measurement for another user. No readings are stored in the
memory when the guest mode is selected.
1. Press and hold the [START/STOP]
button for more than 3 seconds.
The user ID symbol and the date and time display disappears.
2. Release the [START/STOP] button when the date and
time display turns off.
The arm cuff automatically starts to inflate.
DO NOT adjust medication based on readings from this blood pressure monitor. Take medication
as prescribed by your physician. ONLY a physician is qualified to diagnose and treat high blood
pressure.
NEVER diagnose or treat yourself based on your readings. ALWAYS consult with your physician.
Inflating to a higher pressure than necessary may result in bruising of the arm where the cuff is
applied.
NOTE: please refer to "What to do if your systolic pressure is more than 210 mmHg" (page 21) of
this instruction manual for additional information.
To Next Page
Loading...
Need help?
General
