Omron CJ Series - Page 49

7
．
Serial Communications Connection Procedure
46
7
Perform steps 3 to 5 in 7.2.2.
Parameter Settings and display
H.CALIB on Main Display.
Keep pressing the
→
(RiGHT)
or the
←
(LEFT) Keys until
C.INFO is displayed on Main
Display.
Press the ZERO/SET Key once.
8
VER is displayed on Main
Display.
Press the ZERO/SET Key once.
Check the Sensor Controller
version displayed on
Sub-display.
Version: 2.020
*It shows that the Sensor
Controller version is the same
as the one in step 6.
"020