129
5-4. Changing the Arm Position
The arm can be installed on either the left side or the right side of the stand. Use the side that is
most convenient for your installation location and examination environment.
1. Turn the power off.
2. Remove the cable cover.
3. Unfasten the cables (one for the ECG clips and the
other for the PCG sensor) from the fasteners
behind the main unit.
4. Disconnect the ECG clip and the PCG sensor connected on the back of the main unit.
5. Remove the touch pen stand.
6. Loosen the screw (1) and pull out the arm.
BP-203RPE3(A).fm 129 ページ ９年月６日 土曜日 午後５時４分
To Next Page
Loading...
