53
2-3. Measurement Results
Contents of the Measurement Results Screen
The measurement results screen that appears when measurement ends is explained below.
*Select this to perform TBI measurement. The TBI package is required for TBI measurement.
If the TBI package is installed, read the accompanying manual.
1
Blood pressure
value
Displays the blood pressure values at each site where measurement was
performed. Sites where measurement was not performed are not displayed.
2 Graph This graph shows the relationship between baPWV and ABI.
3
[STRESS MODE]
button
Press this to perform stress test.
4
[REMEASUREMENT]
button
Press to repeat measurement. Select "Repeat measurement using same
condition", "TBI measurement"*, or "ABI measurement" for the repeat
measurement condition.
5 Heart Rate Displays the heart rate from the R-R interval obtained from ECG.
6
Heart Rate/
Pulse Rate
Displays the heart rate from the R-R interval obtained from ECG. If "ECG" was
set to "OFF" in the "SELECT MEASUREMENT SENSOR" settings when the
patient's information was entered, displays the pulse rate. (refer to page 34 )
7baPWV
This displays the PWV value calculated from the interval from the start of the
brachial pulse wave to the start of the ankle pulse wave.
8 ABI
Displays the right and left ABI. When blood pressure is measured at both
brachia, the ABI is calculated from the highest brachial pressure value.
9
Synchronization
line
This line indicates synchro measurement. If the time phases do not match due
to re-measurement or other reasons, this line is not displayed.
10 [END] button Press to end measurement and return to the initial screen.
11
[PRINT REPORT]
button
Press to print a measurement results report.
BP-203RPE3(A).fm 53 ページ ９年月６日 土曜日 午後５時４分
To Next Page
Loading...
