Omron E32 - E3 X-MDA Fiber amplifier; 2-in-1 Digital fiber amplifier

19
6
Amplifiers – advanced
E3X-MDA
Fiber amplifier
2-in-1 Digital fiber amplifier
E3X-MDA incorporates 2 digital fiber amplifiers in one slimline housing. For applica-
tions requiring the detection of two objects simultanously the E3X-MDA provides an
easy to use operation saving space and set-up time.
• Two digital amplifiers in one slimline housing
• Twin output models – on/off or area (between two threshold values)
• Signal comparison functions (AND, OR, etc.)
Ordering information
Specifications
Fiber amplifier connectors
Item Functions Order code
NPN output PNP output
Pre-wired AND/OR output E3X-MDA11 E3X-MDA41
Connector version
*1
AND/OR output E3X-MDA6 E3X-MDA8
*1
Order connector separately.
Item E3X-MDA
Light source (wave length) Red LED (650 nm)
Power supply voltage 12 to 24 VDC ±10%, ripple (p-p) 10% max.
Protective circuits Power supply reverse polarity protection, output short-circuit protection, mutual interference prevention
Response time Super-high-speed mode 130 μs for operation and reset respectively
Standard mode 1 ms for operation and reset respectively
High-resolution mode 4 ms for operation and reset respectively
Sensitivity setting Teaching and digital up/down keys
Functions Power tuning Light emission power and reception gain, digital control method
Timer function Select from OFF-delay, ON-delay, or one-shot timer.
1 ms to 5 s (1 to 20 ms set in 1-ms increments, 20 to 200 ms set in 10-ms increments,
200 ms to 1 s set in 100-ms increments, and 1 to 5 s set in 1 s-increments)
I/O settings Output setting (select from channel 2 output, AND, OR, leading edge sync, falling edge sync, or differential output)
Digital displays Select from the following: Incident level for channel 1 + incident level for channel 2, Incident level + threshold, incident level percentage +
threshold, incident light peak level + no incident light bottom level, minimum incident light peak level + maximum no incident light bottom level,
long bar display, incident level + peak hold, incident level + channel
Shape Type Comment Order code
Fiber amplifier
connector
2 m PVC cable E3X-CN21
30 cm PVC cable with M12 plug connector (4 pin) E3X-CN21-M1J 0.3M
30 cm PVC cable with M8 plug connector (4 pin) E3X-CN21-M3J-2 0.3M