EasyManuals Logo

Omron E3Z series Network Connection Guide

Omron E3Z series
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
7
IO-Link Connection Procedure
24
The device variables are named automatically from a combination of the device names and
the port names. For slave units, the default device names are "E" followed by a serial number
that starts from 001. For NX Units, the default device names are "N" followed by a serial
number that starts from 1.
Additional Information
In this document, device variables are automatically named for a unit (a slave).
Device variables can also be manually named for ports.

Other manuals for Omron E3Z series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron E3Z series and is the answer not in the manual?

Omron E3Z series Specifications

General IconGeneral
Protection RatingIP67
Response Time1 ms or less
Accessory TypePhotoelectric Sensor
Connection TypePre-wired, Connector
Sensing MethodThrough-beam, Retro-reflective, Diffuse-reflective
Light SourceInfrared LED, Red LED
Power Supply Voltage12 to 24 VDC
Output TypeNPN, PNP
Operating Temperature-25 to 55°C
Sensing Distancevaries by model (up to 30m for Through-beam)

Related product manuals