Precautions for Correct Use
Installation and Storage Sites
Install and store the product in a location that meets the following conditions:
•
No rapid changes in temperature (place where dew does not form)
• No presence of corrosive or flammable gases
• Place free of dust, salts and iron particles
• Place free of vibration and shock
• Place out of direct sunlight
• Place where it will not come into contact with water, oils or chemicals
• Place not affected by strong electro-magnetic waves
• Place not near to high-voltage, or high-power equipment
• Do not install the product immediately above significant heat sources, such as heaters, trans-
formers, or large-capacity resistors.
• Do not install the Sensor Controller in a cabinet with high-voltage equipment installed.
Mount the Sensor Controller at 200 [mm] or more from power cables apart.
Handling of Sensor Controller
• Touching Signal Lines:
When touching a terminal part or a signal wire in a connector, take anti-static measures using
a wrist strap or another device to prevent damage from static electricity.
• Handling a USB Flash Drive:
Before removing a USB flash drive, make sure that data is not being read or written to them.
For a USB flash drive, the memory device's LED flashes or lights while data is being read or
written, so make sure that it is turned OFF before removing the memory.
Maintenance
• Lightly wipe off dirt with a soft cloth.
• Do not use thinners or benzine.
• Clean the lens with a lens-cleaning cloth or air brush.
• Dirt on the image element must be removed using an air brush.
4 Handling and Installation Environment
4-3
FH Series Vision System Hardware Setup Manual (Z366-E1)
4-1 All Series
4
To Next Page
Loading...