Omron FH-5550 - Page 66

Series FH-3000 Series FH-1000 Series
Type Standard Controller(4 cores) Standard Controller(2 cores)
Model FH-3050
FH-3050-
10
FH-3050-
20
FH-1050
FH-1050-
10
FH-1050-
20
EtherNet/IP Commu-
nication
Yes (Target/Ethernet port)
PROFINET Commu-
nication
• Y
es (Slave/Ethernet port)
• Conformance class A
EtherCAT Communi-
cation
Yes (slave)
Parallel I/O 12 inputs/31 outputs: Use 1 Line. Operation mode: Except Multi-line
random-trigger mode.
17 inputs/37 outputs: Use 2 Line. Operation mode: Multi-line random-
trigger mode.
14 inputs/29 outputs: Use 3 to 4 Line. Operation mode: Multi-line ran-
dom-trigger mode.
19 inputs/34 outputs: Use 5 to 8 Line. Operation mode: Multi-line ran-
dom-trigger mode.
Encoder Interface Input voltage: 5 V ± 5%
Signal: RS-422A Line Driver Level
Phase A/B/Z: 1 MHz
Monitor Interface DVI-I output (Analog RGB & DVI-D single link) x 1
USB I/F USB2.0 host x 4(BUS Power: 5 V/0.5 A per port)
SD Card I/F SDHC x 1
Indicator
Lamps
Main POWER: Green
ERROR: Red
RUN: Green
ACCESS: Y
ellow
Ethernet NET
RUN:
Green
LINK/
ACT
: Yel-
low
NET RUN1: Green
LINK/ACT1: Yellow
NET RUN2: Green
LINK/ACT2: Yellow
NET
RUN:
Green
LINK/
ACT: Yel-
low
NET RUN1: Green
LINK/ACT1: Yellow
NET RUN2: Green
LINK/ACT2: Yellow
SD Card SD POWER: Green
SD BUSY
: Yellow
EtherCAT ECAT RUN: Green
LINK/ACT IN: Green
LINK/ACT OUT
: Green
ECAT ERR: Red
Supply Voltage 20.4 VDC to 26.4 VDC
3 Configuration
3-8
FH Series Vision System Hardware Setup Manual (Z366-E1)