Omron G3PA-VD Series - Page 11

G3PA-(VD)
G3PA-(VD)
142
G32A-A10/G32A-A20
Use the special tool (provided) to extract the cartridge for replace -
ment
with a new one.
Extraction
Follow the procedures below to dismount the Power Device Car-
tridge
from the G3P A.
1. Switch off the power.
2.
Remove the terminal cover .
3. Hook
the indented part of the cartridge with the tool and pull
up on the cartridge to remove it.
Remover
Hook here with
Remover.
Mounting
Follow
the procedures below to mount the Power Device Cartridge
on the G3P A.
1. Apply
silicone grease (provided with the G32A-A) to the entire
surface of the heat radiator .
Apply silicone grease here.
2. Make sure that there is no dust or pieces of wire on the heat
radiator of the G32A-A or the G3P A.
3.
Insert the cartridge into the opening of the G3P A so that the
letters on the cartridge and those on the G3P A are in the same
direction and side A and side B are even.
Side A
Side B
4. Attach the terminal cover .
5. Switch
on the power and check the G3P A to be sure it works
properly.
G32A-A40
The Power Device Cartridge is secured with screws.
Extraction
1. Switch off the power.
2.
Remove the terminal cover .
3. Loosen and remove the two middle screws. These screws
are connected to terminals 1 and 2. (For safety reasons, be
sure to turn the power supply of f.)
Loosen
Loosen
4. Loosen the screws in the corners.
Loosen
Loosen
5. Hold the indented parts on both sides of the cartridge and pull
up on the cartridge to remove it.
Mounting
Follow
the procedures below to mount the Power Device Cartridge
on the G3P A.
1. Apply
silicone grease to the entire surface of the heat radiator .
Apply silicone grease here.
2. Make sure that there is no dust or pieces of wire on the heat
radiator of the G32A-A or the G3P A-240B.
3. Insert the cartridge into the opening of the G3PA-240B.
(Insert
until side A and side B are even.)
Side A
Side B
4. T ighten the screws in the corners. (T ightening torque: 0.59 to
0.78 NSm)
5. Tighten the middle screws. (Tightening torque: 0.59 to 0.78
NSm)
6. Attach
the terminal cover .
7. Switch
on the power and check the G3P A to be sure it works
properly.