Omron H7EC - Page 92

C-98
Multifunction Preset Counter
H7CX
Nomenclature
Reset Operation by Reset Key
1
2
3
4
5
6
9
10
1
2
3
4
5
6
9
10
8
7
11
12
8
7
11
13 14
A
B
C
D
E
F
G
H
I
J
K
L
M
N
Indicators Operation Keys
Switches
Key Protection Indicator (Orange)
Set Value 1, 2 Stage Indicator
Front view of 4-di
g
it mode
l
Front view of 6-di
g
it mode
l
Down Keys: 1 to 4
Key Protect Switch
(Factory setting) OFF ON
DIP Switch
Reset Indicator (Orange)
Lit when the reset input (1) or reset key
is ON.
Control Output Indicator (Orange)
OUT: One stage
OUT1, OUT2: Two stages
Total Count Indicator
Lit when the total count value is
displayed.
Batch Indicator
Lit when the batch count value is
displayed.
Present Value (Main Display)
Character height: 11.5 mm (6-digit: 9mm)
Set Value (Sub-display)
Character height: 6 mm
Mode Key
Used to switch mode and setting items.
Reset Key
The operation of the reset function
depends on the configuration selected
as shown in the table below.
Up Keys: 1 to 4
(6-digit models: 1 to 6)
Configuration Reset operation
1-stage/2-stage
counter
Resets the present value and outputs.
Total and preset
counter
•
Resets the present value and outputs.
•
When the total count value is displayed, resets
the present value, the total count value, and
outputs.
Batch counter •
Resets the present value and OUT2.
•
When the batch count value is displayed,
resets the present value, the batch count
value, and outputs.
Dual counter
Resets the CP1 present value, CP2 present val-
ue, dual count value, and outputs.
Tachometer
Maintains the measured value and outputs (hold
function).