Omron H8CA-S - Programming; Presetting Numeric Values

10
H8CA-S
H8CA-S
Press the key until input mode “N” begins blinking.
Disconnect terminals 1 and 3 before setting values. When termi-
nals 1 and 3 are disconnected, the “ MODE ” display will turn OFF,
and output mode “N” will stop blinking.
Always disconnect terminals 1 and 3 when finished selecting the
function. Values cannot be preset if terminals 1 and 3 are con-
nected.
■
Presetting Numeric Values
Preset values after selecting the function. Values can be preset
whether the power supply is ON or OFF.
Press the key until the desired digit begins blinking.
Press the key to set the desired value.
Continue pressing the and keys until the smallest digit has
been set.
To complete presetting, press the key so that no place on the
display is blinking.
* Preset unnecessary higher digits at 0. (i.e. 000015)
Note: The output will go ON if the set value is 0 (0.0 or 0.00) and
the displayed count is also 0 (0.0 or 0.00). In this case,
press reset after presetting, and the output will go OFF.
Blinking
High-order
digits
Low-order
digits
→→→
key: Press this key to
move to the next
column.
1
↓
2
↓
↓
9
↓
0
…
key: Press this key to
increment values.
Blinking
Blinking