Omron H8CA-S - Programming; Setting Examples

9
H8CA-S
H8CA-S
Blinking
2. Press the key to select counter or timer function, input
mode, and output mode. The characters below will flash
when the key is pressed.
■
Setting Example
1. Selecting the counter function with input
mode “A” and output mode “N.”
(Terminals 1 & 3 connected.)
“ MODE ” lights on the display.
“COUNTS” will begin blinking when the key is pressed. (Press
the keys until the desired place is reached.)
Press the key. “COUNTS” will stop blinking, and one of the
input modes will be blinking.
Press the key until input mode “A” begins blinking.
Press the key. “A” will stop blinking, and one of the output
modes will begin blinking.
Press the key until output mode “N” begins blinking.
Disconnect terminals 1 and 3 before setting values. When termi-
nals 1 and 3 are disconnected, the “ MODE ” display will turn OFF
and output mode “N” will stop blinking.
Always disconnect terminals 1 and 3 when finished selecting the
function. Values cannot be preset if terminals 1 and 3 are con-
nected.
2. Selecting the timer function with “sec” and
output mode “N.” (Terminals 1 and 3 connected.)
If set for timer, “sec” will begin blinking when the key is
pressed. (Press the keys until the desired place is reached.)
Press the key. “sec” will stop blinking, and one of the output
modes will begin blinking. The INPUT MODE will automcally
enter “T.”
Select the
output mode.
For the counter
function, select
the input mode.
Select counter
or timer function.
*Displayed automatically when
the timer function is selected.
COUNTS
hours
min
sec
A
B
C
N
F
C
R
• Press the key until the
desired function appears.
• Press the key to write
the desired input mode.
• Press the key until the
desired function appears.
• Press the key to write
the desired input mode.
• Press the key until the
desired function appears.
• Press the key to write
the desired input mode.
Blinking
Blinking
Blinking
Blinking