19
How to Measure Blood Pressure
■ Canceling measurement
If pain is felt in the arm or discomfort is experienced,
remain calm and press the [START/STOP] switch again.
■
Emergency stop
If a problem is encountered, for example, if the air in the
cuff does not deflate even after the [START/STOP] switch
is pressed, press the [EMERGENCY STOP] switch.
Remove the arm from the monitor, make sure conditions
are safe, and then press the [EMERGENCY STOP] switch
again to reset the monitor.
■
Important points during printing
Do not place the hand or other object near the printer
paper outlet during printing, as this may cause a paper jam.
The printer paper will be cut automatically, so do not
forcibly pull out the printer paper.
Printer paper
HBP-9020.fm 19 ページ ２０１０年７月９日 金曜日 午前８時５９分
To Next Page
Loading...
