2
How to Connect the Electrode Cord (Figure 1A)
1. Turn the Intensity Adjustment Dial/Power Switch to the “OFF” position.
2. Connect the Electrode Cord with the Main Unit. Insert the Electrode Cord Plug into the
Electrode Cord Jack.
3. Connect the Electrode Cord to the Electrode Pads as described below.
When using the unit for the first time (Figure 1B)
• Take out the Pads from the clear plastic bag.
• Do not peel off the clear film attached to the Pad at this time.
• Place the Pad on a flat surface and securely connect the Electrode Cord Plug with the
Pad.
• Although Electrode Cord Plugs are provided in red and white, either plug can be
connected with one of the Pads irrespective of color.
How to Attach the Pad to the skin
1. When you use the unit for the first time, a clear plastic film is attached to the Pad.
2. The Pad has a strong adhesive that is covered in a clear film. Peel off the clear plastic film
from the Pad and attach the Pad to the skin at the junction of the buttock and upper thigh. The
center of the Pad should be placed along the line of the gluteal fold (Figure 2).
3. Discard the peeled-off clear film – do not reapply to the pad.
4. It may be difficult for you to attach the Pad behind your body around the buttock. It is a good
idea to ask someone in your family or caregiver to help you.
5. If the Pad comes off from the skin, the unit will
turn off automatically in approximately 7 seconds.
Turn the Power to OFF, then re-attach the Pads
correctly and turn on the power again.
General Advice on the handling of Pad
• Do not place pads one on top of the other.
• Do not bend the Pad.
• Do not touch the adhesive surface with your fingers.
• Ensure you wipe sweat off the region you want to put Pads before using the unit.
• If the Pad becomes adhered to clothing or another item and does not come off easily, do
not use force to peel it off. Instead, moisten the back of the cloth to which the Pad is
attached with a small amount of water, and then the Pad will come off easily.
• If you need to wet the Pad let it dry sufficiently. Especially let the adhesive surface air-
dry.
To Next Page
Loading...
Need help?
General
