13
How to Treat
This section explains the treatment procedure and the entire operation flow from turning on the power
to storing of the unit.
Four treatment methods are available. Select your favourite one to receive treatment.
– Treat with the Soothe Button
When you want to improve blood circulation.
– Treat with the Relieve Button
When you want to relieve pain.
– Treat with the Region Button
When you want to treat the selected region of shoulder, joint, arm, sole, leg (calf), and waist (lower back) with
the program.
– Treat with the Massage Button
When you want to treat the region according to your symptom and favourite operation by selecting the
massage method from Tapping, Kneading, Pushing, and Rubbing.
Have you connected the Electrode Cord? (Refer to Page 10.)
Have you attached the Pads to the regions you want to receive treatment? (Refer to Page 11.)
1. Turn on the power.
Rotate the Intensity Adjustment/Power Dial Switch downwards.
When you hear a click, the power is turned on and the treatment
starts.
❇ When you use the unit for the first time, the Shoulder light will flash
and WIDE will be displayed. When you use the unit for the second
time and after, the Buttons you used in the previous treatment will
flash (except for the Hyper Mode.)
2. Select one treatment method.
– Treat with the Soothe Button (Refer to Page 15.)
– Treat with the Relieve Button (Refer to Page 16.)
– Treat with the Region Button (Refer to Page 17.)
– Treat with the Massage Button (Refer to Page 18.)