Omron MicroHAWK ID-40 - Modify NA-HMI Panel IP Address; Set NA-HMI Panel TCP;IP Settings; Initiate NA-HMI Panel Connection

Modify NA-HMI Panel IP Address
17. NA-HMI Panel Download
17.1. In the Multiview Explorer, expand “Conguration and Setup” and double-click “HMI Settings”. Click
the “TCP/IP” button, circled below, to view the IP Address for Ethernet Port 1 on the NA-HMI panel.
17.2. Change the NA-HMI panel to the desired IP Address. Ensure that the IP address is on the same subnet as
the NJ/NX controller.
28
Technical Note: MicroHAWK ID-40 360
º
Barcode Reading Solution
TECHNICAL
NOTE