6 Maintenance and Troubleshooting
6-22
NB-series Programmable Terminals Startup Guide Manual(V109)
After a password is set, the password needs to be entered correctly to carry out uploading, or
not, the uploading cannot proceed; you can disable uploading completely by deselecting [Allow
Upload]. If [Allow Decompilation] is selected and a password is set, the correct password is
required to be entered to proceed with decompilation. If [Allow Decompilation] is deselected,
decompilation cannot be performed even after a project is uploaded.
Note that if the project is large and decompilation is not required, then decompliation can be
deselected to save the storage space of the PT.
31
How to mask system alarm information - PLC No Response
Place a [Bit Button Component] in the Common Sheet, with the address being LW.B 9296.2
and the setting type being [Set On when Screen Open].
32
How to mask system alarm information - Socket Connect Error
Place a [Bit Button Component] in the Common Sheet, with the address being LW.B 9296.4
and the setting type being [Set On when Screen Open].
33
How to achieve multi-language switch
Multi-language switch can be achieved through changing the value of the special memory
LW9130. The default setting is: LW9130=0, with the corresponding language 1.
NB-Designer supports up to a maximum of 32 languages. The following is an example of
Chinese - English switching:
LW9130=0: Language 1ÆChinese
LW9130=1: Language 2ÆEnglish
(a) Create a text in the text library, as shown below:
To Next Page
Loading...
Need help?
General
