Omron NJ Series Troubleshooting Manual

3-181
3 Error Tables
NJ-series Troubleshooting Manual (W503)
3-2 Events in Order of Event Codes
3
3-2-2 Error Table
940A0000 hex FTP Server Started Built-in EtherNet/IP Port on CPU Unit W506
940B0000 hex NTP Client Started Built-in EtherNet/IP Port on CPU Unit W506
940C0000 hex SNMP Started Built-in EtherNet/IP Port on CPU Unit W506
94200000 hex Notice of Insufficient Travel Distance
to Achieve Blending Transit Velocity
General Motion Control W507
94210000 hex Error Clear from MC Test Run Tab
Page
General Motion Control W507
94220000 hex Slave Error Code Report General Motion Control W507
94400000 hex Slave Disconnected Built-in EtherCAT Master in CPU Unit W505
94410000 hex Slave Connected Built-in EtherCAT Master in CPU Unit W505
94430000 hex Errors Reset Built-in EtherCAT Master in CPU Unit W505
94440000 hex* Slave Disabled Built-in EtherCAT Master in CPU Unit W505
94450000 hex* Slave Enabled Built-in EtherCAT Master in CPU Unit W505
94600000 hex* I/O Check Execution Started NX-series EtherCAT Coupler Unit W519
951E0000 hex* Sysmac Studio Communications
Connection Timeout
NX-series Safety Control Unit Z930
951F0000 hex* Clear All Memory Rejected NX-series Safety Control Unit Z930
95300000 hex* DB Connection Service Started DB Connection Service W527
95310000 hex* DB Connection Service Stopped DB Connection Service W527
95320000 hex* DB Connection Service Shutdown DB Connection Service W527
98010000 hex Absolute Value Cleared Servo G5 I576
98020000 hex Position Data Initialized Servo G5 and G5 Linear I576, I577
Event code Event name Functional classification Reference

Omron NJ Series Specifications

General

Program Capacity	Up to 128 MB
SD Card Slot	Yes
Power Supply Voltage	24 VDC
Motion Control	Yes
USB Ports	1
Operating Temperature	0°C to 55°C
Communication Interfaces	Ethernet/IP, EtherCAT, USB
Safety Function	Optional
Storage Temperature	-20°C to 75°C
Communication Ports	USB
Dimensions	Varies by model
Weight	Varies by model