Need help?Do you have a question about the Omron NX1P and is the answer not in the manual?
Details Omron's warranty terms, limitations, and buyer remedies for products.
Outlines limitations on Omron's liability for damages and indirect losses.
Explains the concept of using user-defined variables for NX1P programming, contrasting with address-based methods.
Introduces Sysmac Studio as an integrated environment for configuring, programming, and maintaining controllers.
Provides step-by-step instructions and system requirements for installing Sysmac Studio.
Guides on creating a basic ladder program using Sysmac Studio with pushbuttons and lamps.
Explains how to assign variable names to physical terminals for I/O mapping.
Demonstrates using a self-holding rung and a timer instruction in a ladder program.
Introduces PLCopen®-defined function blocks for motion control in NX1P.
Details registering a servo drive and configuring its axis parameters for motion control.
Demonstrates creating a program using motion FBs to control single-axis movement.
Details Omron's warranty terms, limitations, and buyer remedies for products.
Outlines limitations on Omron's liability for damages and indirect losses.
Explains the concept of using user-defined variables for NX1P programming, contrasting with address-based methods.
Introduces Sysmac Studio as an integrated environment for configuring, programming, and maintaining controllers.
Provides step-by-step instructions and system requirements for installing Sysmac Studio.
Guides on creating a basic ladder program using Sysmac Studio with pushbuttons and lamps.
Explains how to assign variable names to physical terminals for I/O mapping.
Demonstrates using a self-holding rung and a timer instruction in a ladder program.
Introduces PLCopen®-defined function blocks for motion control in NX1P.
Details registering a servo drive and configuring its axis parameters for motion control.
Demonstrates creating a program using motion FBs to control single-axis movement.
General| Model | NX1P |
|---|---|
| Power Supply | 24 VDC |
| Programming Software | Sysmac Studio |
| Built-in EtherNet/IP port | Yes |
| Built-in EtherCAT port | Yes |
| Built-in USB port | Yes |
| SD memory card slot | Yes |
| USB Port | 1 |
| Communication Ports | EtherNet/IP, EtherCAT, USB |
| Ethernet Ports | 1 |
| Operating Temperature | 0 to 55 °C |
| Weight | 500 g |
| Type | Programmable Logic Controller (PLC) |
To Next Page