3-35
3 Configuration Units
NJ-series CPU Unit Hardware User’s Manual (W500)
3-7 Sysmac Studio
3
3-7-2 Connection
The Sysmac Studio cannot connect online to an NJ-series CPU Unit in the following type of con-
figuration.
• If the built-in EtherNet/IP port is not used, you cannot connect to an NJ-series CPU Unit on an
EtherNet/IP network.
Example: Connection through
an EtherNet/IP Unit
Example: Connection to NJ-series CPU Unit Routing through an Eth-
erNet/IP Unit or Built-in Port
• You cannot route through any networks other than EtherNet/IP networks.
Sysmac Studio
EtherNet/IP
EtherNet/IP Unit
(CJ1W-EIP21)
Sysmac Studio
USB
EtherNet/IP
CS1W-EIP21, CJ1W-EIP21, CJ2 Built-in EtherNet/IP port,
or CJ2M Built-in EtherNet/IP port
Sysmac Studio
Controller Link Unit, DeviceNet Unit, etc.
Controller Link network,
DeviceNet network, etc.
USB
To Next Page
Loading...
