1 Introduction to NJ-series Controllers
1-6
NJ-series CPU Unit Hardware User’s Manual (W500)
Refer to the NJ/NX-series CPU Unit Software User’s Manual (Cat. No. W501) for details on the net-
work configuration.
Support Software
You can use the following Support Software to set up, monitor, and debug an NJ-series Controller.
Sysmac Studio
The Sysmac Studio is the main Support Software that you use for an NJ-series Controller. On it, you
can set up the Controller configurations, parameters, and programs, and you can debug and simu-
late operation.
Other Support Software
The following Support Software is also included in the Sysmac Studio Software Package Standard
Edition.
*1 If the NJ/NX-series Controller is a target device, you may also use Sysmac Studio version 1.10 or higher.
Use the Network Configurator if a CS/CJ-series PLC operates as the originator device.
Configuration software Application
Sysmac Studio
The Sysmac Studio is used for sequence control, motion control, and all other
operations except those described below.
Network Configurator
The Network Configurator is used for tag data links on EtherNet/IP ports or
Units.
*1
CX-Integrator
The CX-Integrator is used for remote I/O communications with a DeviceNet
Unit or CompoNet Master Unit.
CX-Protocol
The CX-Protocol is used for protocol macros with Serial Communications
Units.
CX-Designer The CX-Designer is used to create screens for NS-series PTs.
To Next Page
Loading...
