Omron NX Series Manual

NX-CSG/SL5/SI/SO
13
Version Information
Relationship between the Unit Versions of Safety Control Units and Sysmac Studio Versions
This section describes the combinations that can be used of the unit versions of the Safety Control Unit and the Communication Control Unit, and
the version of the Sysmac Studio.
Safety Control Units
*1. The data types in the following table are supported for communications between NX Units.
*2. Communications between NX Units are not supported.
NX Unit Corresponding unit version/version
Model Unit version Communication Control Unit Sysmac Studio
NX-SL5500 Ver. 1.3 Ver. 1.01 Ver. 1.24 or higher *1
NX-SL5700 Ver. 1.3 Ver. 1.01 Ver. 1.24 or higher *1
NX-SIH400 Ver. 1.0 Ver. 1.00 Ver. 1.24 or higher *2
NX-SIH400 Ver. 1.1 Ver. 1.00 Ver. 1.24 or higher *2
NX-SID800 Ver. 1.0 Ver. 1.00 Ver. 1.24 or higher *2
NX-SOD400 Ver. 1.0 Ver. 1.00 Ver. 1.24 or higher *2
NX-SOH200 Ver. 1.0 Ver. 1.00 Ver. 1.24 or higher *2
Supported data types
BOOL
BYTE
INT
WORD
DINT

Omron NX Series Specifications

General

Programming Languages	Ladder, Structured Text, Function Block Diagram, Sequential Function Chart
Communication Ports	Ethernet, USB, RS-232C, RS-485
Memory Capacity	Varies by model
Program Memory	Varies by model
Data Memory	Varies by model
Operating Temperature	0°C to 55°C
Power Supply	24 VDC
Ethernet Ports	1 or 2 ports (depending on model)
USB Ports	1 or 2 ports (depending on model)
Dimensions	Varies by model
Weight	Varies by model