Omron RC212 - Applying the Wrist Cuff Correctly; Wrist Cuff Application Procedure; Cuff Application Caution

14
2. Preparation
2.3 Applying the Wrist Cuff
Note
• Following steps are for applying the wrist cuff to your left wrist. When you take a
measurement on your right wrist, apply the wrist cuff using the same steps as on
your left wrist.
• The blood pressure can differ between the right wrist and the left wrist, and the
measured blood pressure values can be different. OMRON recommends to
always use the same wrist for measurement. If the values between both wrists
differ substantially, please check with your physician as to which wrist to use for
your measurements.
Caution
• Remove tight-fitting, thick clothing and any accessories from your wrist while
taking a measurement.
1. Roll up sleeve.
Make sure your sleeve is not rolled up too tightly on
your arm. This may constrict the flow of blood in
your arm.
2. Put your wrist through the cuff loop.
Your palm and monitor display should both face upward.
Wrist cuff