Omron SEM-2 - Applying the Arm Cuff Correctly; Preparing and Inserting the Arm Cuff

Be sure to wrap the arm cuff correctly so that you get accurate results.
Measurements can be taken in light clothing. However, please remove
thick clothes, such as sweaters, before taking a reading.
1. Insert the air plug into the air jack on the
left side of the main unit.
2. Put your left arm through the cuff loop.
The air tube should run down the inside of
your forearm and be in line with your
middle finger.
NOTE: If the cuff is not assembled, pass the
end of the cuff furthest from the
tubing through the metal D-ring to
form a loop. The smooth cloth should
be on the inside of the cuff loop.
HOW TO APPLY THE ARM CUFF
15
EN-02-31[SEM-2]-3 8/23/05 8:58 AM Page 15