Omron SEM-2 - Battery Installation and Management; Installing and Replacing Batteries

9
1. Turn the main unit over.
2. Slide the battery cover in the
direction of the arrow while pressing
the ribbed part of the cover.
3. Install or replace four “AA” size
batteries so that the + (positive) and
- (negative) polarities match the
polarities indicated on the battery
compartment.
4. Replace the battery cover.
Slide the battery cover as indicated, until it clicks into place.
NOTE: The monitor memorizes previous measurement results even when
the batteries are replaced.
HOW TO INSTALL/REPLACE THE BATTERIES
EN-02-31[SEM-2]-3 8/23/05 8:58 AM Page 9