Omron SEM-2 User Manual

TO DELETE ALL THE READING
You cannot delete individual stored readings, all the readings will be
deleted.
1. To delete stored measurement results,
while the memory values are
displayed, first press the MEMORY
button. Then while holding it down,
press the START/STOP button
simultaneously for about 2-3 seconds.
All results will then be deleted.
NOTE: Be careful not to press the
START/STOP button first.
If the START/STOP button is
pressed first, the monitor will be
turned off.
2. Press the START/STOP button to turn the monitor off.
If you forget to turn the monitor off, it will automatically shut itself off
after five minutes.
NOTE:
If the date and time are reset to a time before the most recent
measurement, the average value will be based on any measurements
taken after the date and time were reset. However, you can still view the
readings stored in memory.
HOW TO USE THE MEMORY FUNCTION
23
1
2
EN-02-31[SEM-2]-3 8/23/05 8:58 AM Page 23

Omron SEM-2 Specifications

General

Brand	Omron
Model	SEM-2
Category	Blood Pressure Monitor
Language	English