Omron Sti F3SJ-B N25-01T Series - Wiring Examples; 5-1. Auto reset mode, external test used

2
F3SJ-B-01T
Quick Installation Manual
2. System Components
3. Light Curtain Setup Flow
4. Function Selection Flow Chart
Wiring depends on the function to be used. Shown below are the available functions.
- External Test Function
- Auxiliary Output Function
For details, refer to F3SJ-B-01T series user's manual.
10. Bottom-beam-state indicator (Blue)
6. Test indicator (Green)
5. Power indicator (Green)
4. Lockout indicator (Red)
3. ON/OFF-state indicator (Green/Red)
2. Stable-state indicator (Green)
1. Top-beam-state indicator (Blue)
4. Lockout indicator (Red)
3. ON/OFF-state indicator (Green/Red)
2. Stable-state indicator (Green)
1. Top-beam-state indicator (Blue)
7. Internal error indicator (Red)
6. Configuration indicator (Green)
5. Communication indicator (Green)
Emitter
Receiver
10. Bottom-beam-state indicator (Blue)
Emitter
Receiver
Connection cable
(Black)
Indicator
Beam
Extension cable
Connection
cable (Gray)
Beam center-line mark
Setup
Function Selection
Wiring
Mounting/Beam Alignment
Pre-Operation Checklists/Maintenance Checklists
Done
. . . .page 2
. . . .page 3
. . . .page 4
. . . .page 10