Omron SYSMAC C28K Installation Guide

16
Model
CPU
I/O Unit
I/O Unit
Analog
Timer
Unit
C20K
C28K
C40K
C60K
C16P
C4K
C4K
–TM
A
±0.2
240
240
290
340
145
31
31
B
250
250
300
350
155
40
40
C±0.2
100
100
100
120
100
100
100
D
110
110
110
140
110
110
110
E
5
5
5
15
5
5
5
F
15 to 40
G
15 to 35
H
20 to 40
I
80 to 130
Attach End Plates (PFP–M) to both ends (as shown below) when connecting
CPUs, Expansion I/O Units, or Analog Timer Units to a DIN Rail. It is also
recommended that a Spacer (PFP–S) be installed between a CPU and Ex-
pansion I/O Unit when they are mounted horizontally.
XX
510 10
End plate
DIN Rail
Spacer End plate
CPU I/O Unit
Mounting screws are included with CPUs, Expansion I/O Units, and Analog
Timer Units. They must be purchased separately for I/O Link Units.
2–4 I/O Connecting Cable
Applicable connecting cable will vary according to which Units are connected
and whether they are mounted horizontally or vertically. All Expansion I/O
Units except the C16P and C4K use C20P–CN501 cable (5 cm) for horizon-
tal mounting and C20P–CN411 cable (40 cm) for vertical mounting. The
C16P and C4K cannot be mounted vertically. The C16P can use either of the
above–mentioned cables for horizontal mounting. The C4K can use only
C4K–CN501 cable (5 cm). For connecting I/O Link Units, use C20P–CN711
cable (70 cm).
CAUTION:
Always be sure to use only the cable that is included with the Unit. Using the
wrong cable (such as the C20 I/O Connecting Cable or I/O Link Connecting
Cable) for connecting Expansion I/O Units can cause serious damage to the
Units.
I/O Connecting Cable Section 2–4

Omron SYSMAC C28K Specifications

General

Brand	Omron
Model	SYSMAC C28K
Category	Controller
Language	English