What to do if I see a disconnection error with my Omron Accessories?
If you're experiencing a disconnection issue with your Omron Accessories, it indicates a disconnection has been detected in the input. To resolve this, check both the sensing element and the wiring for any faults.
Why am I getting a temperature specification setting error on my Omron Accessories?
If you encounter a temperature specification setting error with your Omron Accessories, it means an error was detected in the setting of the temperature specification. You should recheck the K (CA)/J (IC) selection (pin 4) on the back panel of the Unit, the specified area (word n bits 08 through 13) for the temperature specification codes, and the setting program.
What to do if my Omron Accessories show a memory error?
If you are facing a memory error with your Omron Accessories, it indicates that the internal memory (storing modified data) of the Unit is defective. Possible causes include disturbance from noise or hardware irregularity. If the alarm flag persists after removing the disturbance and repeatedly turning the power ON and OFF, replacement may be necessary.
How to fix 'Outside range' error on Omron Accessories?
If your Omron Accessories display an 'Outside range' error, it means the input exceeds the tolerance of ±10% for the temperature specification range. To fix this, confirm that the temperatures you're measuring are within the specified range.
General| PLC Type | Modular |
|---|---|
| Operating Temperature | 0 to 55°C |
| Programming Language | Ladder logic |
| Data Memory | 512 words |
| Communication Ports | RS-232C |
| Humidity | 10 to 90% RH (non-condensing) |
| Supply Voltage | 100 to 120 VAC, 200 to 240 VAC, 24 VDC (depending on the power supply unit) |
Identifies the target audience for the manual, typically engineers.
Outlines general safety and operational guidelines for using OMRON products.
Details critical safety warnings to prevent injury, fire, or electric shock.
Specifies conditions to avoid for proper and safe operation of the unit.
Provides solutions for common errors encountered during unit operation.
To Next Page
