EasyManua.ls Logo

Omron Total Power + Heat PM800 - Page 29

Omron Total Power + Heat PM800
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
5.2 Cleaning
The cord with pads and the device can be cleaned, but you cannot clean the gels.
Cleaning the cord with pads
1 Remove the gels and discard before cleaning the pads.
• The gels cannot be cleaned.
2 Wipe the surface with a soft cloth moistened with
water or a neutral detergent.
• Do not get the cord wet.
• Do not wash the pads with running water.
3
Let air dry before placing new gels onto the pads, do not use old gels.
Gels are replaceable and can be purchased when needed by calling 1-800-634-4350 or going
to OmronHealthcare.com.
Cleaning the device
1
Turn the device o and disconnect the cord with pads from the device.
2 Wipe the surface of the device with a soft cloth that has been moistened with water or neutral
detergent, then dry completely using a soft cloth.
• Do not use chemicals such as thinner and benzene to clean the device.
• Do not let water get into the internal area of the device.
When to replace the gels?
Replace the gels when they no longer stick rmly to your skin, or if more than 25 % of the gel is not
in contact with your skin, replace the gel.
5.3 Disposal
Dispose of the device and battery in accordance with local government regulations.
5. MAINTENANCE

Related product manuals