Omron Total Power + Heat PM800 - 2. Preparing Your Device; 2.1 Battery Charging Procedure

12
2. PREPARATION
2.1 Charging
• If you are using the device for the rst time or the device has not been used for more than three
months, charge the battery to full.
• Once fully charged, the battery will last for approximately four 30-minute uses on average. Once
the battery has been depleted, it takes about ve hours to charge.
• Recommended temperature during battery charging: 41 °F to 95 °F (+5 °C to +35 °C)
1 Connect the AC adapter plug to the AC adapter jack on the device.
2 Plug the AC adapter into an electrical outlet.
CAUTION
• DO NOT use any AC adapter other than the one provided in the packaging of this device .
Note:
• Make sure not to place your device in a location where it is dicult to plug and unplug the AC
adapter.
• When charging the battery, the “Battery” symbol ashes on the screen.
Charging
• When fully charged, the symbol ( ) will ash shortly on the screen, then power will be
turned o. Press the [Power] button to check that the battery is fully charged.
• For the battery status, refer to “Battery” (Page 13).
Rechargeable battery inside
o
f device (DO NOT REMOVE)
Electrical outlet