Hardware Setup
15
N300 WiFi ADSL2+ Modem Router (N300RM)
5. Connect a computer.
You can use an Ethernet cable or connect wirelessly.
• Use the yellow Ethernet cable to connect your computer to an Ethernet port on your
modem.
• Or connect wirelessly by using the preset wireless security settings on the label on
the bottom of the router
.
6. Open a browser
.
The first time that you connect to your modem, the browser automatically displays a modem
routerscreen to help you set up your Internet connection.
If this screen does not display, see the following section, Tips for Connecting to the
Modem Router on page 16.
If you already connected to the modem and used this screen, you are prompted to log in.
See Log In to the Modem Router on page 19.
7. Connect any additional wired computers to your modem router by inserting an Ethernet
cable from a computer into one of the three remaining LAN ports.
Note: To use the modem router on the same network as another router, you
need to change the Device Mode setting to Modem mode. See Change the
Device Mode on page 102.
To Next Page
Loading...
Need help?
General
