ASSEMBLY INSTRUCTIONS
LSA7700P
READ THIS MANUAL CAREFULLY BEFORE ASSEMBLING AND USING THIS
PRODUCT. KEEP THIS MANUAL IN A SAFE LOCATION FOR FUTURE REFERENCE.
WARNING
1.
Take one lighting arm, and position its clamp on the upper
vertical shaft at the desired height.
2.
Look at the clamp label and be sure the clamp is right side up.
3
. Check to ensure the vertical shaft is fully inside the clamp
opening (See figure A).
4
. Tighten the large steel knob at the end of the clamp.
5
. Repeat with the other lighting arm. Both clamps should be
right side up (See figure B).
POSITIONING THE CLAMPS WITH THE LABELS UPSIDE DOWN
WILL CAUSE THE ARMS TO SAG.
IMPORTANT
ALWAYS MAINTAIN A BALANCED STAND. THE CLAMPS SHOULD
BE POSITIONED 180° APART FOR STABILITY AND SAFETY.
CAUTION
Vertical shaft must
be fully inside the
clamp opening
Fig. A
Fig. B
Congratulations! You have purchased the
LSA7700P u-mount Lighting Arms. You’ll find
this system to be the fastest and easiest way
to add lights to your existing speaker or
lighting stands. With proper care, these arms
will last for years to come.
We hope you enjoy your
new purchase!
LIGHTING ARMS
®
Your LSA7700’s are pre-assembled and ready to use right
away. Set up your speaker or lighting stand following the
manufacturers recommendations, then follow the steps below:
To Next Page
Need help?
General
