Onan MDKBH Series

5-1
5. Enclosure, Drip Pan and Mounting System
ENCLOSURE PANELS
WARNING
Accidental or remote starting can
cause severe personal injury or death. Before
removing a panel or access door, disconnect
the negative (–) cable at the battery to prevent
the engine from starting.
The genset enclosure panels and access doors are
assembled as shown (Figure 5-1).
Back Panel
This panel is secured by 5 screws along its left edge
(looking from the back), 3 along its right edge and 7
on its back. Remove this panel for access to the
generator drive (Page 7-1).
BACK
PANEL
AIR INTAKE
DUCT
TOP AC-
CESS
DOOR
STANDOFF
INSULATOR
GENERATOR
GROUNDING STRAP
LEFT ACCESS
PANEL
GENSET
GROUNDING
SCREW AS-
SEMBLY
AC OUTPUT
BOX
FRONT / LEFT
SIDE PANEL
ASSEMBLY
DOOR
LINTEL
FRONT AC-
CESS DOOR
OUTPUT
BOX COVER
RIGHT SIDE
PANELS
FIGURE 5-1. GENSET ENCLOSURE
Redistribution or publication of this document, 
by any means, is strictly prohibited.